Safe and Vault Movers

Guide · Businesses · 4 min read · Updated 17 November 2026

Safe Grades Explained: What EN 1143-1 Means for You

Short answer

EN 1143-1 is the European standard for testing safes, strongrooms and vault doors against burglary. Safes are tested by an independent body and given a grade, with higher grades resisting attack for longer. Insurers commonly set cash and valuables cover limits by grade. Higher-grade safes are usually heavier and must be anchored correctly, which affects the cost and method of moving them.

Safe Grades Explained: What EN 1143-1 Means for You

What EN 1143-1 is

EN 1143-1 is the European standard that sets out how secure storage units such as safes, strongroom doors and vault doors are tested for resistance to burglary. Testing is carried out by independent laboratories, which attack the safe with a range of tools and measure how much effort is needed to break in. The safe is then given a grade. Higher grades have resisted longer, more determined attacks with more powerful tools.

A graded safe usually carries a label or plate inside the door showing the standard and the grade, along with the certification body. This is the information insurers and safe engineers look for.

How grades relate to insurance

Insurers often decide how much cash or valuables they will cover in a safe based on its grade. A higher grade typically allows a higher cover limit, and the limit for valuables such as jewellery is often higher than for cash. The exact figures vary between insurers and policies, so check your own policy rather than relying on general tables.

Most insurers also require the safe to be installed and anchored in line with the manufacturer's instructions. A graded safe that is not fixed down may not meet the policy conditions.

  • Check the grade label inside the safe door
  • Ask your insurer what cover limit applies to that grade
  • Confirm whether the policy requires the safe to be anchored
  • Keep installation records after a move
  • Tell your insurer before moving a safe to a new address

Grade, weight and moving

Higher-grade safes are built with thicker steel, composite barrier materials and heavier doors, so they are usually much heavier than ungraded or lower-grade safes of a similar size. That affects how they are moved. A small ungraded home safe might be handled by two people with a stair-climbing trolley, while a high-grade commercial safe could need powered equipment, skates, a gantry or a crane.

The table shows how safe type and weight usually relate to moving cost.

Safe typeTypical weight bandGuide moving price
Small home or ungraded safeUp to 150kg£180–£350
Lower-grade or larger home safe150–400kg£350–£750
Higher-grade commercial safe400–1,000kg£750–£1,800
Vault door or strongroom equipmentOften several tonnesfrom £2,500

Anchoring after a move

Moving a safe means its anchor bolts are removed, so it needs to be refixed at the new position. Installation and anchoring starts from £150 and uses the manufacturer's anchor kit, drilled into a solid concrete floor or wall. The quality of the fixing matters, because a safe that can be levered off the floor or carried away is much less secure regardless of its grade.

Where the new floor is timber or the wall is a stud partition, discuss alternatives with the installer. They might suggest a different position or a concrete base to anchor into.

Fire resistance is different

Burglary grades and fire ratings are separate. A safe can be graded for burglary resistance under EN 1143-1 and also tested separately for fire resistance, which shows how long it keeps paper or data media below a certain temperature in a fire. Some safes are designed mainly for fire protection and offer limited burglary resistance. Check both ratings if you need protection from theft and fire.

What to tell your mover

If you know the grade, tell your mover along with the make and model. It helps them estimate the weight and decide on equipment. Ask them to note how the safe was anchored before the move and to refix it at the new address using the correct kit. Keep a record of the work for your insurer. If the safe has been damaged or opened by force in the past, mention that too, as it can affect its certification.

Common misunderstandings and choosing a new safe

A frequent misunderstanding is that any heavy safe is a secure safe. Weight helps, because it makes a safe harder to carry away, but it does not tell you how long the body and door resist attack. An ungraded safe of the same size may be far weaker than a graded one. The grade label, not the weight, is what an insurer will look for.

Another is assuming that an old graded safe still qualifies for the same cover. Policies and insurer requirements change, and a safe that has been damaged, repaired with non-standard parts or had its lock replaced may not be treated as the original grade. If you inherit a safe with a property, or buy a second-hand one, ask your insurer and a safe engineer whether it can still be relied on for its grade.

Finally, some owners assume a safe is covered wherever it stands. Many policies require the safe to be at a specific address and anchored. Moving it without telling your insurer, or leaving it unfixed after the move, can affect a claim.

If a move is a chance to upgrade, think about what you need to store and its value, the insurance cover required and where the safe will go. A heavier, higher-grade safe offers more protection but needs a floor that can support it and an anchoring point. It is often worth speaking to your insurer and a safe engineer before buying, then having the safe delivered and installed in one visit rather than moved twice.

Questions people also ask

What does safe grade mean?

A safe grade shows how well the safe resisted independent burglary testing under a standard such as EN 1143-1. Higher grades resisted longer and stronger attacks. Insurers commonly use the grade to decide how much cash and valuables they will cover in the safe.

Does moving a safe affect its grade?

Moving a safe does not change its grade, but it must be reinstalled and anchored correctly at the new address. Many insurers require graded safes to be fixed in line with the manufacturer's instructions, so a safe left unanchored after a move may not meet your policy conditions.

Are higher-grade safes harder to move?

Usually, yes. Higher-grade safes are built with thicker steel and barrier materials, so they weigh more. They often need powered stair climbers, skates, gantries or cranes rather than a simple trolley, and heavy units usually need a site survey before a price is fixed.

Written and checked by the Safe and Vault Movers team. Read our editorial policy.

Get a free safe and vault movers quote

Tell us what you need and we'll come back with a clear price.

Request a quote